Polymer dispersant Polymeric Dispersing Agent BYK9010 UV Ceramic 3D Printing: Dispersion, Viscosity Reduction, Anti-Settling Stabilization
GENERAL DESCRIPTION
Anjeka-6910A is a wetting and dispersing additive for unsaturated polyester and epoxy systems. It stabilizes inorganic pigments, especially titanium dioxide, and significantly reduces the viscosity and improves the flow of the mixture.
PRODUCT DATA
Chemical composition: Copolymerization blends containing acidic groups
Typical Physical and Chemical Data:
The data given on this data sheet are typical values and are not product specifications.
Appearance: Brownish-yellow liquid
Acid value (mg KOH/g): 100-300
Density g/cm³ (23℃): 1.10-1.30
Viscosity cps (25℃): 100-800
Active ingredient (%): 100
STORAGE AND TRANSPORT
Delamination or turbidity may occur at temperatures below 10℃, and can be recovered by heating to 30℃-40℃.
Storage time is not recommended to exceed 12 months.
APPLICATION MESSAGE
This additive is recommended for solvent-borne and solvent-free systems to stabilize inorganic pigments, especially titanium dioxide. It effectively reduces the viscosity of the system and improves the fluidity of the system.
RECOMMENDED LEVELS
Dosage of additives: (W/W) based on inorganic fillers or pigments 0.5%-1%.
The above data are empirical, the optimum dosage should be determined through a series of tests.
INCORPORATION AND PROCESSING INSTRUCTIONS
For best performance, add the dispersant to the resin first and then add the filler or pigment.
PACKAGING
-25kg iron drum with inner coating
-200kg ring plastic drum
Our service:
| 1. Reply within 24 hours. |
| 2. High-quality products and reasonable price |
| 3.R&D technology support. |
| 4. Professional team service |
| 5. Customiszed production for different package |
| 6. No delay on shipment |
|
|
wetting and dispersing additive for UV Ceramic 3D Printing: Dispersion, Viscosity Reduction, Anti-Settling Stabilization Images
|
